
Subject: Overheating
Models: 1981 - 4 with Neutral
We have had some reports of overheating on the 1981 4 models with neutral shift. Overheating can result from exhaust gases entering the water pump due to improper sealing of the water pump plate to the gearcase and/or the pump housing.
Should you receive an outboard with an overheating condition, we recommend that the gearcase be removed and the water pump disassembled. Place a bead of OMC Adhesive M (P/N 318535) on the base of the water pump housing (See Figure 1) and on the surface of the gearcase surrounding the water inlet. See Figure 2. Then reassemble the pump.


The powerhead must be removed to detach the neutral shift linkage to allow removal and reassembly of the gearcase. See Figure 3. The shift rod incorporates several bends to clear the water pump assembly. This requires that the shift rod be inserted in the gearcase before the gearcase is attached to the exhaust housing. Install a new cylinder to exhaust housing gasket P/N 327169 coated with OMC Gasket Sealing Compound P/N 317201.

This condition has been corrected on outboards after the following serial numbers:
Evinrude
E4BRCI - 01838
Johnson
J4BRCI - 5382858
After completion of this repair submit a warranty claim for a powerhead gasket P/N 327169 and 1.5 hours of labor. Place this service bulletin number on the “Explanation of Dissatisfaction” area.