OMC Outboard Service Bulletin No. 2023, published May, 1981, addresses oil pump housing puller p/n 982799 for 1973-77 V-4, 1976-78 V-6 Outboards and 1978 Thru 400 and 800 Series OMC Stern Drives.

Oil Pump Housing Puller, P/N 982799 (See A) has been designed to remove the oil pump housing from the lower gearcases on the 1973-77 V-4, 1976-78 V-6 and 1978 thru 400 and 800 Series Stern Drives. When the oil pump housing is difficult to remove follow these directions for using the puller.

A. Oil Pump Housing Puller P/N 982799
1. Pulling Rod
2. Pulling Pin
3. Installation Rod
4. Plate
5. Nut



a. Insert large end of pulling rod into gearcase and thru propeller shaft plunger hole in oil pump. See B.
b. Turn pulling rod until hole in rod aligns with shift rod hole in oil pump.
c. Thread pulling pin onto installation rod.
d. Insert pin and installation rod into shift rod cavity of gearcase. See C.
e. Insert pulling pin into shift rod hole in oil pump. Rotate pin until flat aligns with set screw on pulling rod. (This screw is for alignment only, do not adjust or tighten.) Seat pulling pin completely into oil pump. Unscrew installation rod from pulling pin and set rod aside.
f. Position plate onto pulling rod with grooved end of plate facing gearcase.
g. Assemble nut onto pulling rod. Hold flats of rod using a wrench. See D.
h. Turn nut on pulling rod to remove oil pump.
Suggested products related to this service bulletin. Verify fit and suitability before ordering.
Search for original or compatible replacement part 982799
Click here to search on eBayAffiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.