
Isolated cases have occurred in which the rear anode has been lost from V-6 outboard gearcases.
When installing a new anode, follow this procedure:
1. If the anode to gearcase screw has broken off, remove the part left in the gearcase.
2. Retap the screw hole in the gearcase to 5/16-18 size. See Figure 1.
3. Flatten the area around the screw hole with a file. See Figure 1.
4. Position the new anode with a larger hole (P/N 393023) in gearcase cavity. Apply OMC Screw Lock to the new, larger screw (P/N 328096) and install it without a lockwasher. See Figure 2. Tighten the screw to a torque of 10-12 ft. lbs. (14-16 N·m).


Note Do not paint over the anode. The anode material must directly contact the water to be effective.
If the customer decides an anode is unnecessary, a filler block (P/N 327482) and screw (P/N 326469) may be installed in place of the anode. Tighten the filler block screw to torque of 5-7 ft. lbs. (7-9 N·m). Do not tap the screw hole to a larger size if the filler block is to be used.
The screw hole in the gearcase must be plugged if neither the anode nor the filler block is used. A 1/4-20 stainless steel screw should be used as a plug.
Note The unplugged screw hole would reduce the water flow to the exhaust cooling nozzle in the gearcase. The result of insufficient water spray in this area would be burned propeller shaft seals and rubber propeller hub.