April 1982 OMC bulletin on factory oversize cylinder identification and replacement procedures.
OMC Outboard Service Bulletin
Powerhead
No. 2042
April, 1982

Subject: Oversize Cylinders on New Motors

Models: All Outboard, OMC Sea Drive®, and Sail Drive, All Years

Each year a very limited number of new motors are assembled with cylinders bored larger than standard size. These motors perform as well as, and are no different in appearance from, any other new motor. The letters “OS” stamped on the powerhead number plug identifies them.

Service on these motors is the same except for cylinder repair. Wear or damage that could ordinarily be repaired by reboring, will require a new cylinder and crankcase assembly.

OMC Service has established a simple procedure for equalizing the cost of cylinder repair on these motors that are out of warranty.

  1. After determining the need for reboring, complete a warranty claim form including model and serial numbers and a statement that the motor had factory bored oversize cylinders and now needs reboring to repair.
  2. Include the cost of reboring a block at your reboring shop.
  3. List the part number of a new cylinder and crankcase assembly for the motor being repaired.
  4. Enclose a check from the dealership for the amount that would cover the cost of reboring the block. Make the check payable to OMC Service Department. The new cylinder and crankcase will be sent freight prepaid by OMC.

When the warranty claim form and check are received by the OMC Warranty Department, an order will be placed at OMC Parts and Accessories for a new cylinder and crankcase assembly to be sent directly to your dealership. Service Replacement Cylinder and Crankcase Assemblies will be the standard bore size. All other expenses will be the responsibility of the customer.

Order standard size pistons, ring sets and other items necessary to complete the repair from your OMC Parts Distributor.

Carefully remove the number plug from the old block, remove the letters “OS” and install the plug in the new cylinder and crankcase assembly.

Hold the old parts for 60 days for possible return request.

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Cylinder Hone Tool, Piston Ring Compressor

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.