June 1982 OMC bulletin on high performance V-6 motor mounts and steering setup.
OMC Outboard Service Bulletin
Midsection
No. 2046
June, 1982

Subject: High Performance Motor Mounts

Models: All V-6 Outboards

High performance boat and motor combinations must be set up carefully. Inadequate or careless rigging can cause unstable performance.

The boat steering system must be a dual cable type that can be adjusted to eliminate all slack and free play.

Optional lower motor mounts may be required on the engine to reduce instability if dual cable steering alone does not stabilize the boat.

When installing the lower mounts on CI V-6 models, care must be used. The mounts were changed in midproduction. The 1976 through 1979 models, CS models, and some CI models use a mount with 3/8” diameter screw holes. The remaining CI and later V-6 models use a lower mount with 7/16” diameter screw holes.

To determine which mount is used on a CI V-6, note the letters at the end of the model number on the motor. If the last three letters are “CIH” (example: E235TRLCIH), the mounts will have the smaller 3/8” screw holes. The correct high performance mount for the “CIH” models is P/N 387998.

Motors that have the last three letters “CIM”, “CIA” and “CIB” (example: J200TLCIB) will have mounts with 7/16” screw holes. The high performance mount for these models is P/N 391774.

Enter a note in the CI V-6 parts catalog for future reference.

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Boat Steering Cable Grease

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 387998

Search for original or compatible replacement part 387998

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.