
Subject: Connecting Permanent or Portable Fuel Systems to Motors.
Models: CT V-4 and V-6 Outboards
The CT V-6 and early production CT V-4 models have a fuel nipple rather than a fuel connector on the lower motor cover. This allows a 5/16” I.D. U.S.C.G. approved Type A fuel hose from a permanently installed fuel system to be attached directly to the nipple on the motor. A clamp to fasten the hose to the nipple is included in the Owner’s Kit.
Permanently installed fuel tanks are vented to the atmosphere outside the boat hull. This prevents pressure build-up in the fuel system so the fuel hose can remain attached to the motor.
If portable fuel tanks are to be used with these models, replace the fuel nipple on the lower motor cover with Fuel Connector P/N 393334 and Hose Clamp P/N 322654. A kit P/N 174119 containing the fuel connector and clamp will be available. Do not remove the connector from the motor cover when using a portable tank hose.
⚠ Safety Warning: A portable fuel tank hose must not be permanently attached to the nipple on the motor because fuel spillage can occur through the carburetors if the fuel system becomes pressurized. Fuel spillage can contribute to possible fire or explosion.
Portable fuel tank systems are equipped with two valves. One valve, located in the connector at the motor end of the fuel hose, closes to stop fuel flow when the hose is disconnected from the motor. The other valve is located in the fuel cap. When the vent screw is open the one way valve in the cap allows air to enter the tank as fuel is being used. The one way valve does not allow pressurized fuel vapor in the tank to vent into the atmosphere. Because these tanks are not vented to the atmosphere, pressure can build up in the fuel system, especially when the tank is heated by sunlight. The Owner’s Manual instructs the operator to disconnect the fuel hose from the motor whenever the boat is trailered, docked or left tilted up on the transom for longer than a few minutes. Disconnecting the hose will prevent fuel from being spilled from the carburetors by a pressure build-up in the fuel system.
OMC fuel tanks, fuel connectors and fuel tank hose assemblies are recommended for use when portable tank fuel systems are used. Fuel tank and hose assemblies P/N 388920, 392065 or 392999 are the only approved tanks for use with V-6 models.
Permanently installed fuel systems and portable tanks and hoses, other than those manufactured by OMC, must be tested for adequate fuel supplying capability. A procedure for testing fuel systems is described in Service Bulletin No. 2003, July, 1980 and Service Letter No. 18, December, 1981. Minimum requirements for sizes of fuel hoses and metal fuel lines are also included in these bulletins.