
Insufficient fuel supply can cause problems in motors. These problems can vary from poor performance to permanent powerhead damage.
Fuel System Service Bulletin No. 2003 and Service Letter No. 18 deal with requirements of built-in fuel systems. Attention must be given to the capability of the boat fuel system, especially when a V-6 model is to be mounted on the boat.
The common symptoms indicating a lack of sufficient fuel:
- As the throttle is advanced, motor speed will increase to a high RPM but will fall back to a lower speed even though the throttle control remains at a high setting.
- The motor speed will surge up and down when the throttle control is at a high setting.
- Motor stalls when retarding from the full throttle position.
If the motor still indicates a lack of fuel after the boat fuel system and motor carburetors have been eliminated as a cause of the problem, replace both fuel pumps on the motor with new higher performance pumps. These new pumps will tolerate more vaporized fuel in the line than the previous pumps.
The new fuel pumps are available in two kits. The kits include a molded-bend hose that must be used on some replacements, but is discarded on other applications.
Replacement fuel pump applications -
• 1976 V-6 outboards:
Replace the upper pump with kit P/N 393868 - discard the hose in the kit.
Replace the lower pump with kit P/N 393868 - Cut 5 cm. (2 in.) from the long portion of the molded-bend hose and install the hose. See the instructions included in the kit.
• 1977-1978 V-6 outboards:
Replace the upper pump with kit P/N 393868 - discard the hose in the kit.
Replace the lower pump with kit P/N 393870 - discard the hose in the kit.
• 1979, CS, CI, CN and CT V-6 outboards:
Replace the upper pump with kit P/N 393870 - discard the hose in the kit.
Replace the lower pump with kit P/N 393868 - install the molded-bend hose from the kit.

• CN 2.5, 2.6 Litre OMC Sea Drive models:
Replace the upper pump with new pump P/N 393646.
Replace the lower pump with kit P/N 393868 - install the molded-bend hose from the kit.
Note The molded bend hose included in the kit must be used when replacing the lower pump on 1976, 1979, CS, CI, CN and some CT V-6 outboard models. Failure to install the hose can result in a fuel leak or powerhead damage or both conditions.
Some CT V-6 outboard models and CN 2.5, 2.6 Litre OMC Sea Drive models will have the new pumps already installed. The standard pump, see ①, and the new pump, see ②, are compared for identification.
Tighten the pump mounting screws to a torque of 2.71 - 4.07 N·m (24-36 in. lbs.). After tightening the mounting screws, tighten the lower middle pump screw Ⓐ to 2.71 - 4.07 N·m (24-36 in. lbs.). See ②. The filter cover screw may have to be loosened and the cover nipple rotated away from the screw to allow tightening.


A new fuel pump repair kit P/N 393867 is required to rebuild the new high performance fuel pump.