OMC Service Bulletin No. 2071, published March 1983, addresses lean condition at full throttle. The original factory instructions and illustrations are reproduced below.
OMC Outboard Service Bulletin
Fuel SystemNo. 2071March 1983

Subject: Lean Condition at Full Throttle

Models: CT 150 Outboards built after the following serial numbers:

Johnson 150TLCTE - Serial No. 5850458
Johnson 150TXCTE - Serial No. 5852028
Evinrude 150TRLCTE - Serial No. 288678
Evinrude 150TRXCTE - Serial No. 290406

Symptom: Engine performs poorly at or near full throttle. Lean condition can be detected by depressing the key switch, to turn on primer enrichment system, while running at high speed. If rpm increases engine is running lean.

Cause: Carburetor assemblies P/N 394338 (upper and lower) and P/N 394339 (middle) are built with correct metering components, but may have incorrect carburetor body casting with too large a venturi.

Remove air silencer cover and air silencer. Carburetor venturi size is identified by cast numbers on front of carburetor. Correct carburetor should have 1-1/4 (A). Incorrect carburetor has 1-3/8 (B).

Factory carburetor venturi comparison A and B

Solution: One, two or all three carburetors may be wrong. Replace incorrect carburetor(s) with new carburetor assembly 394338 (upper and lower) and 394339 (middle).

Related marine products

eBay: OMC / Evinrude part 394338

Listings matching the part number

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.