OMC Service Bulletin No. 2073, published April 1983, addresses water leaks at driveshaft seal. The original factory instructions and illustrations are reproduced below.
OMC Outboard Service Bulletin
GearcaseNo. 2073April 1983

Subject: Water Leaks at Driveshaft Seal

Models: 1977 Through 1983 (RS-RW & RP) 25 Models

There have been some reports of leaking driveshaft seals when 1977 thru 1983, 25 models are operated in silty water. Installation of one original type seal and one improved type seal will provide improved sealing.

Note: Apply OMC Gasket Sealing Compound to the metal casing of the seals before installing.

1 Install the original type inner seal P/N 321786 (A) using OMC special tool P/N 326555 (upper drive-shaft seal installer) as shown. Lip facing toward gearcase.

2 Install the improved type outer seal P/N 321459 (B) using OMC special tool P/N 326555 (upper drive-shaft seal installer) as shown. Lip facing away from gearcase. Drive until lower seal bottoms or top seal is flush with top of gearcase.

Apply OMC Triple-Guard grease liberally between seals after installing.

Figure 1 inner driveshaft sealFigure 2 outer driveshaft seal

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Lower Unit Gear Oil Pump

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 321786

Search for original or compatible replacement part 321786

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.