OMC Service Bulletin No. 2076-rev-1

August 1983 OMC Bulletin No. 2076 Rev. 1 describing flywheel and crankshaft taper lapping for 2.6 Litre XP and GT high-performance outboards.

OMC Outboard Service Bulletin
Powerhead
No. 2076 Rev. 1
August, 1983

Subject:Lapping Flywheel/Crankshaft Taper

Models:2.6 Litre, XP and GT
High Performance/Competition Racing Outboards

Whenever the flywheel is removed from the 2.6 Litre, XP and GT High Performance/Competition Racing Engine, the flywheel/crankshaft must be lapped to increase service life of the engine.

11. Obtain the following materials: OMC Cleaning Solvent P/N 390905, OMC Ultra Lock P/N 388517 and fine valve lapping compound purchased locally.
22. Clean taper of flywheel hub, using OMC Cleaning Solvent P/N 390905.
33. Remove flywheel key from crankshaft. The upper main crankshaft seal must be protected against lapping compound. Apply a liberal bead of OMC Triple-Guard Grease around the crankshaft just above the seal.

Note Damage to the powerhead may occur if lapping compound is embedded between the seal and the crankshaft.

Clean crankshaft taper and threads.

44. Apply fine valve lapping compound to inside bottom of flywheel taper.

(Continued)

Factory photograph for instruction 1Factory photograph for instruction 2Factory photograph for instruction 3Factory photograph for instruction 4
CR 83-20 Rev. 1
55. Install flywheel onto crankshaft, rotate flywheel clockwise and counter-clockwise to lap both crankshaft and flywheel.
66. Remove flywheel, inspect crankshaft and flywheel taper for a uniform satin finish. Continue lapping process until uniform satin finish is achieved.
77. Remove the grease that is protecting the seal. Clean flywheel, crankshaft taper and threads with OMC Cleaning Solvent P/N 390905.
88. Apply even coat of OMC Ultra Lock P/N 388517 to bottom of flywheel taper and install flywheel onto crankshaft. Rotate flywheel back and forth 45° one time. Remove flywheel and wipe excess OMC Ultra Lock from crankshaft taper.
99. Install flywheel key into crankshaft and install flywheel. Apply OMC Ultra Lock P/N 388517 to threads of new flywheel nut.
1010. Tighten flywheel nut to a torque of 200-203 N·m (148-150 ft. lbs.). Do not retorque flywheel nut as this will cause OMC Ultra Lock to be ineffective. Future removal of flywheel will require more effort than normal.
Factory photograph for instruction 5Factory photograph for instruction 6Factory photograph for instruction 7Factory photograph for instruction 8Factory photograph for instruction 9Factory photograph for instruction 10

Related marine products

eBay: OMC / Evinrude part 390905

Listings matching the part number

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.

Related products

OMC Cleaning Solvent 390905 and Ultra Lock 388517 - recommendations coming soon.