
Subject: Improperly Operating Fuel Pumps (Small Square Style)
Models: CT 4 thru 15
Symptom - Engine stalls after idling for short time (when float chamber empties). Runs acceptably throughout range above idle.
1Cause - Improperly operating fuel pump. Some fuel pumps were manufactured with valve seat imperfections that prevent valves from seating. The problem will not occur if there is pressure in the fuel tank. This may result in customer complaints that vary depending if the tank is pressurized or not. Fuel pumps with this problem may show up on new motors or in replacement parts inventory.
Diagnostic Procedures - Perform a lift test using visual observation. The motor must be operated using a portable fuel tank with the fuel level 24” lower than the fuel pump. The filter screen on the fuel pump should be inspected for restrictions prior to conducting the test.
Equipment Required - Fuel Connector P/N 173247, 1/4” or 5/16” ID clear tubing 3’ long, and a portable fuel tank.
• Start motor and allow to warm up (using standard fuel hose and primer bulb).
• Reduce speed to 700 RPM in gear.
• Remove fuel tank cap.
2• Connect clear tubing to fuel connector. Attach fuel connector to motor and place other end in fuel tank.
• Watch for fuel to be lifted to engine. Fuel pump will lift fuel only when the float valve opens; therefore, it may take some time for the fuel to be lifted.
• A good fuel pump will lift fuel the entire height and continue to run.
Solution - If pump will not lift fuel the entire 24”, the pump is defective. Replace fuel pump and repeat test.

