This August 1983 bulletin documents the improved red low-speed adjusting needle retainer and its installation procedure for earlier outboard carburetors.
OMC Outboard Service Bulletin
Fuel System
No. 2084
August, 1983

Subject:   Improved Adjusting Needle Retainer P/N 315232 (Red)

Models:   1983 and Earlier Outboards Using Low Speed Needle Retainer P/N 315232 (White)

Symptom: Low speed adjusting needle rotates open or closed resulting in loss of correct mixture adjustment.

Cause: Retainer does not provide sufficient friction on needle.

Solution: Replace the adjusting needle retainer with new (red) retainer P/N 315232 using the following procedure:

•   Remove air silencer or choke bracket (if equipped).

•   Remove low speed needle.

1•   Use a “hook” tool to remove the retainer from “key hole” slot of carburetor.

2•   Use a large flat punch to bottom new retainer in cavity.

•   Install low speed needle and adjust to recommended initial setting.

•   Install air silencer or choke bracket (if equipped).

•   Run motor in test tank or on boat. Refer to the current service manual for specific mixture adjustment procedure.

Factory figure 1: removing retainerFactory figure 2: installing retainer

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Carburetor Cleaner Spray, Jet Cleaning Wires

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 315232

Search for original or compatible replacement part 315232

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.