OMC Outboard Service Bulletin No. 2086, September, 1983, addresses setting idle rpm for All V-4 and V-6 Outboards.
OMC Outboard Service Bulletin
Shop Information
No. 2086
September, 1983
Subject:Setting Idle RPM
Models:All V-4 and V-6 Outboards

We have received a number of calls from dealers who are trying to set the idle RPM on V-4 and V-6 outboards while running the engine on a “flushette.” Without the exhaust backpressure of a submerged gearcase, the engine will run lean. Trying to adjust for this condition will result in an incorrect idle RPM setting.

To properly set the idle RPM, the engine must be on the customer's boat, in the water and have the correct propeller installed. If this is not possible, the motor should be submerged to a water level A just above the lower motor mount B and have the correct test wheel installed. The water must be at least two inches above the water pump and no higher than six inches below the exhaust relief outlets C. When setting idle RPM the engine must be at normal operating temperature and in forward gear. The idle setting for all V-4 and V-6 outboards is 650 RPM.

Lower unit diagram showing water level, motor mount, and exhaust relief outlets
CR 83-50

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Propeller Hub Kit

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.