OMC Outboard Service Bulletin No. 2089, October, 1983, addresses testing speed control for Electric Trolling Motors.
OMC Outboard Service Bulletin
Electric Outboards
No. 2089
October, 1983
Subject:Testing Speed Control
Models:Electric Trolling Motors

Symptom - Little or no detectable speed change, when speed control is changed, with propeller out of water.

Cause - When an electric outboard is tested out of water, the propeller has no load, making changes of speed difficult to detect.

Equipment Required - 0 to 40 amp ammeter.

Diagnostic Procedure - To check an electric outboard at all speeds, the propeller must be in the water. Turn the speed control to each speed and observe propeller thrust in water. Submerging the motor and propeller will also insure proper cooling of components.

If you cannot detect speed changes, install a 0 to 40 amp ammeter in series with the black negative ground lead to battery. Turn the speed control to 1, low; 2, normal; and 3, high. Ammeter should indicate a different current for each speed.

CR 83-39

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Propeller Hub Kit

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.