October 1983 OMC bulletin covering propeller modification and diagnostic checks for 50 through 235 HP outboards using through-hub exhaust propellers.


1Solution - Modify the propeller by drilling three 6mm (7/32") holes A thru outer shell positioned as shown in the diagram. If there is a rib B under any of the proposed hole locations, use another propeller. Properly drilled, the holes will have no affect on top speed, maximum RPM or ventilation in turns. Incorrect hole size or location will result in no improvement or in excessive ventilation, particularly in turns.
Drilling the holes allows exhaust gases to bleed onto the propeller blades causing controlled ventilation during acceleration. This allows the motor to turn higher RPM under acceleration providing more power to plane the boat. Review the Diagnostic Procedures for additional items that will contribute to poor acceleration.
(Continued)
Diagnostic Procedure - The boat and motor should be inspected for the following conditions:
Suggested products related to this service bulletin. Verify fit and suitability before ordering.
Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.