OMC Service Bulletin No. 2095

December 1983 ignition bulletin on maximum spark advance checking for 70 HP through V-6 and OMC Sea Drive engines.

OMC Outboard Service Bulletin
Ignition System
No. 2095
December, 1983

Subject:   Changes to Maximum Spark Advance Adjustment Procedures

Models:   All 70 thru V-6 and OMC Sea Drive® Models

The current recommendation for the maximum spark advance adjustments should be checked at 5000 RPM minimum in forward gear. Magneto CD ignition systems have the characteristic to automatically increase the spark advance as RPM increases. If the maximum spark advance is checked at less than 5000 RPM it will be too far advanced when the engine is operated at higher speeds.

Some repair facilities are not equipped to run larger engines at 5000 RPM. The following procedure is permissible when the recommended procedure cannot be followed:

NoteThis procedure is NOT an alternate method for checking maximum spark advance. It is not as accurate as the recommended procedure as described in the service manual. This procedure should be used ONLY until the recommended procedure can be performed. Improper spark advance will result in poor engine performance or serious powerhead damage.

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Inductive Ignition Timing Light

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.