
The early production trim and tilt model outboards required the ignition switch to be in the “ON” position to operate the trim and tilt. Later production motors use a fused connection that allows the trim and tilt to be operated with the ignition off.
This feature can be added to your customer's motor by installing a 3 amp. fuse and lead assembly. Use OMC Fuse and Lead Assembly P/N 582723.
Use the following instructions to install the fuse and lead assembly.
1. Disconnect the battery cables at the battery before working on electrical equipment to prevent arcing or damage to equipment.
2. Disconnect the purple lead Ⓐ from the junction box terminal Ⓑ and the terminal strip terminal Ⓒ.
3. Pull the purple lead out of the protective sleeve it shares with the red lead. Discard the purple lead.
4. Install the red/white fuse lead Ⓓ (from the engine side) through the starboard hole in the junction box. Connect the lead to the starboard lower terminal Ⓔ where the purple lead was removed.
5. Install the red fuse lead Ⓕ (from the engine side) through the port hole in the junction box. Connect the lead to the same terminal Ⓖ that the red lead is attached.
6. Tighten the terminal screws securely. Coat the terminals with OMC Black Neoprene Dip P/N 909570.
7. Connect the battery cables to the battery. Tighten the terminals securely.


Related marine products
Amazon: Marine battery cable
Related marine supplies
eBay: OMC / Evinrude part 582723
Listings matching the part number
Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.