OMC Outboard Service Bulletin No. 2103 (1984) addresses new fuel inlet nipple on v-6 outboards. Fuel line and primer component requirements for CR V-6 outboards.

OMC Outboard Service Bulletin
Fuel System
No. 2103
February, 1984

Subject: New Fuel Inlet Nipple on V-6 Outboards Models: All CR V-6 Outboards

The CR V-6 models are equipped with a large fuel inlet nipple ® requiring a 3/8” I.D. fuel line.

When installing fuel line from a permanently installed boat fuel tank, use one of the following kits for fuel line priming:

[2] Electric Primer Pump Kit P/N 394301 A convenient dash mounted toggle switch allows priming of the complete fuel system from a specially designed marine primer pump. The pump’s inlet and outlet are 1/4’ female pipe thread and will require fuel nipples P/N 173312 to attach a 3/8” I.D. fuel hose.

[3] Fuel Hose and Primer Bulb Assembly P/N 174174

This assembly incorporates a new larger primer bulb with a 2.6 m (8.5 ft.) 3/8” I.D. fuel hose.

[4] Primer Bulb Kit P/N 174160

This larger capacity primer bulb will allow use of bulk 3/8” I.D. fuel hose to customize fuel system installation.

Note When using the new 3/8” fuel primer bulb mMake sure that the primer bulb is installed with the arrow indicating fuel flow toward the engine.

When an anti-syphon valve must be incorporated in the fuel system to provide anti-syphon protection, Anti-Syphon Valve P/N 173274, 1/4’ male pipe thread to 3/8” I.D. fuel hose, may be used.

Factory figure 1 for bulletin 2103Factory figure 2 for bulletin 2103Factory figure 3 for bulletin 2103Factory figure 4 for bulletin 2103
1 / 2

When using portable fuel tanks, install hose and connector assembly P/N 394751. This will permit use of a quick disconnect fd fitting from a portable tank.

The recommended portable fuel tank for V-6 outboards is P/N 392065. This is a 6 gallon tank that comes with a 6’ hose and primer bulb, quick disconnect fitting and a filler cap with vent screw.

Recommended OMC fuel lines and kits:

Electric Primer Pump Kit P/N 394301

3/8” I.D. Fuel Hose & Primer Bulb Assembly P/N 174174

3/8" I.D. Primer Bulb Kit P/N 174160

Fuel Hose & Connector Assembly P/N 394751

3/8” I.D. Reinforced Type “A’’ Fuel Line - 25’ Roll P/N 123111 3/8’ I.D. Vinyl Fuel Line - 50’ Roll P/N 329655

Do not use vinyl hose (OMC fuel tank hose) for permanent installations. Use vinyl hose only for connection from drywell ~ or portable tanks to engine. [6]

Factory figure 5 for bulletin 2103Factory figure 6 for bulletin 2103
2 / 2

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Fuel Line Assembly (3/8" Primer Bulb)

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 394301

Search for original or compatible replacement part 394301

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.