OMC Service Bulletin No. 2104 - Revised Ammeter Recommendations

February 1984 OMC guidance recommending voltmeters instead of ammeters on specified trim/tilt outboards.

OMC Outboard Service Bulletin
Accessories

No. 2104
February, 1984

Subject:
Revised Ammeter Recommendations
Models:
CR 70 thru V-6 Trim/Tilt Models and Commercial 65 thru V-6 Trim/Tilt Models
Problem:
Ammeters are not recommended for use on the above models because:
  • Ammeter installations would require modification to the engine cable assembly.
  • 35 amp systems require heavier gauge wires than supplied in kits. These wires add significant cost to the installation.
  • OMC ammeter kits only have a 15 amp capacity.
Cause:
The above models all use a powerhead mounted trim/tilt junction box which has wiring different from previous models. The wiring instructions in the current OMC Ammeter Installation Instructions do not apply to these models.

Note Use of the OMC ammeter kit will result in trim/tilt power being supplied through the ammeter circuit. This would result in ammeter damage as the trim/tilt amperage draw exceeds 15 amps in some modes of operation.

Solution:
A voltmeter is recommended for use on these models. Some of the advantages of a voltmeter over an ammeter are as follows:
  • Purchase price less than ammeter
  • Less labor required to install
  • Convenient monitoring of battery condition
  • Immediate check of alternator operation
Action Required:
Notify all sales and service personnel of this important ammeter recommendation.

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Universal Marine Outboard Tachometer / Boat Dash Gauge

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.