OMC Service Bulletin No. 2105 - Securing and Protecting Electrical Cables in Lower Engine Cover

February 1984 OMC instructions for securing lower engine-cover electrical cables on CR trim/tilt models.

OMC Outboard Service Bulletin
Electrical System

No. 2105
February, 1984

Subject:
Securing and Protecting Electrical Cables in Lower Engine Cover
Models:
CR Trim/Tilt Models with Powerhead Mounted Junction Box

1 Bundle the electrical cable, the tilt/trim cable, battery cables and the VRO low oil warning wire. Wrap the bundle using the rubber wrap A supplied with the battery cables. Install tie strap B (supplied) around rubber wrap. Locate the tie strap so its connection is facing down to fit in cavity in lower engine cover. Tighten and cut off any free end of tie strap.

2 Place cables and rubber wrap in opening in front of lower engine cover. Make sure tie strap connection nests into lower engine cover cavity. Install clamp C over rubber wrap. Secure clamp with 2 screws.

⚠ Safety Warning

Wrap and secure cables carefully. Any damage to insulation of battery cables can result in shorting of the battery during installation or later when motor may be unattended. Shorting/grounding will cause positive (+) battery cable to overheat and may result in fire.

Figure 1 cable bundle with rubber wrap and tie strapFigure 2 cable clamp placement

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Dual Battery Switch, Battery Box

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.