OMC Service Bulletin No. 2107 - RPM Limiter Power Packs

February 1984 OMC ignition-system bulletin describing RPM-limiter power packs and their model applications.

OMC Outboard Service Bulletin
Ignition System

No. 2107
February, 1984

Subject:
RPM Limiter Power Packs

Some CR and Commercial models are equipped with RPM limiter power packs to prevent powerhead damage caused from overspeeding. When engine RPM exceeds a preset level, the engine will begin to hesitate. This occurs because the power pack interrupts the ignition system intermittently. When this happens, the throttle should be reduced until the engine runs without hesitation. If this situation becomes persistent, then the engine should be checked for a worn propeller, ventilation or a reason which may have caused the consistent overspeeding.

When replacing power packs, do not substitute a non-limiter power pack on models originally equipped with an RPM limiter power pack. Certain models use two RPM limiter power packs where the 2.6 GT & XP models use one non-limiter and one limiter pack. Below is a list of models equipped with RPM limiter power packs and their service replacement part numbers. RPM limiter power packs are identified by ā€œLā€ after the pack designation number.

OMC #DesignationModelQty. Per ModelLimits At:
582474CD2L25 & 55 Commercial15800 RPM
582864CD2/62L816200 RPM
582901CD2/50L40 Commercial15000 RPM
582684CD4L100 Commercial25700 RPM
582712CD6/62L2.6 GT & XP1 Stbd.6200 RPM
582556CD3/6L65 Commercial / 155 Commercial1 / 25700 RPM