OMC Service Bulletin No. 2115 - Jackman Model 741 Outboard Engine Tester

Published July, 1984, this factory bulletin addresses jackman model 741 outboard engine tester.

OMC Outboard Service Bulletin
Electrical System
No. 2115
July, 1984
Subject:Jackman Model 741 Outboard Engine Tester
Models:All Outboard and OMC Sea Drive® Models with Rectifier/Regulator Charging System

Problem -

When using the Jackman Model 741 to test motors equipped with a rectifier/regulator, the diode in the charging circuit of the Jackman 741 must be bypassed or the alternator will not charge.

Solution -

⚠ 1. Disconnect battery leads from the battery.

2. Remove the six screws (A) and plate (B) from the back of the tester.

3. Attach a jumper lead (C) from the diode terminal (D) to the lower terminal (E). Make sure the jumper clips are attached securely and do not interfere with other components.

4. Reinstall the plate and the six screws securely.

5. Reconnect the battery terminals making sure the terminals are tightened securely.

NoteIf the battery leads are not tightened securely to the battery terminals or to the Jackman 741 tester battery terminals, it will cause an open circuit between the motor rectifier/regulator charging system and the battery. This condition will cause damage to the rectifier/regulator.

NoteRemove the jumper lead when running motors that are not equipped with a rectifier/regulator charging system.

NoteDo not operate motors to exceed 25 amps charging rate or the ammeter on the tester may be damaged.

CR 84-107

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Dual Battery Switch, Battery Box

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.