There have been some reports of motor interference with boat motor wells when 120/140 models are fully tilted. Each motor installation must be checked for adequate motor well clearance as part of the motor installation. These motors are designed to operate without interference within a boat’s motor well built to ABYC specifications.
Check motor tilting and turning clearance as follows:
1. Tilt the motor to the full tilt position and turn it fully side to side while observing clearance from motor to the motor well. If remote control cables, electrical components, or fuel system components interfere with the tilting of the motor, reroute them to provide adequate clearance.
2. If the motor contacts the motor well area, consider raising the motor on the transom to provide adequate clearance, OR
3. If the motor cannot be raised to provide adequate clearance, modify the motor well to provide clearance. Refer to Motor Well Dimensions on the next page.
Note If clearance is not adequate, remote control cables, fuel system hoses, steering components, and engine covers can be damaged when the motor is at full tilt position.
Safety Warning: If the motor strikes a solid underwater object, the motor rotates rapidly to a full tilt position. The shock absorbing system requires the full tilt travel of the motor to function properly and effectively. Failure to ensure clearance could result in damage to motor mounting parts or to shift, throttle, and steering system parts. Such damage could result in sudden loss of boat control.




