OMC Service Bulletin No. 2146 - Double Flashing from Timing Light

Published February 1985. Timing-light double flashes can be caused by RF pickup or a poor sensor-lead connection.

OMC Outboard Service Bulletin
Ignition System
No. 2146
February, 1985
Subject:
Double Flashing from Timing Light
Models:
All Evinrude® and Johnson® Outboards, OMC Sea Drive® Models
Symptom:
When checking timing, double flashes from the timing light may occur.
Problem:
The timing light induction pickup is usually cupped over the high tension lead between the ignition coil and spark plug. The timing light may be picking up RF (radio frequency) signals causing the light to flash at the wrong time. On the 3-cylinder, V-4, and V-6 models, double flashing can also be caused by a poor connection of the white (common) sensor lead at the plug-in connector between the timer base and the power pack.
Solution:
To eliminate RF signals, connect the timing light induction pickup to the ignition coil primary lead which connects the ignition coil to the power pack. If double flashing continues, lower the sensitivity of the clamp on the induction pickup Ⓐ by placing a strip of electrical tape Ⓑ across the pickup, as shown.

If double flashing occurs and is not a result of RF signals, check the connection of the white lead wire pin and socket in the plug and receptacle between the timer base and power pack.

Timing light pickup with electrical tape, labels A and B

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Spark Plugs (Champion/NGK)

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.