OMC Service Bulletin No. 2147, issued April 1985, addresses inoperative tachometer for 115 CO Manual Tilt.

OMC Outboard Service Bulletin
Accessories

No. 2147
April, 1985

Subject: Inoperative Tachometer

Model: 115 CO Manual Tilt

Johnson serial number 7069051 thru 7069243; Evinrude serial number 1065651 thru 1065923

Problem: The above models were shipped without the jumper bar installed on the powerhead terminal board. If a tachometer is to be installed or has not operated properly, the following modification must be made.

1. If jumper bar A was not installed between terminals B and C:

  • Remove gray lead D from terminal C.
  • Secure gray lead D to terminal B with yellow/gray striped wire.
  • Apply OMC Black Neoprene Dip to connection.

3. If jumper bar A is connected between terminals B and C:

  • Inspect all leads and connections from terminal board to tachometer.
  • Refer to service manual to check charging system.
Factory illustration 1 for bulletin 2147Factory illustration 2 for bulletin 2147Factory illustration 3 for bulletin 2147

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Universal Marine Outboard Tachometer / Boat Dash Gauge

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.