OMC Service Bulletin No. 2150 - Water Entering Lower Engine Cover

Historical OMC factory service information covering water entering lower engine cover for Evinrude and Johnson 275 and 3.6 XP/GT CO Models.

OMC Outboard Service Bulletin
Powerhead
No. 2150
April, 1985
Subject:Water Entering Lower Engine Cover
Models:Evinrude and Johnson 275 and 3.6 XP/GT CO Models
Problem:On some models the rear drain holes in the lower engine covers allow water to enter.
Solution:Reduce the drain hole size using reducer plugs A as follows:

Order reducer plugs from OMC Customer Service Department in Waukegan, Illinois.

1. Clean the reducer plugs and the surface around the two rear drain holes where the plugs are to be installed on lower engine covers.

2. Apply “Loctite Super Bonder” adhesive or another type of cyanoacrylate sparingly around the drain hole surface. (Lower engine cover removed for photos.)

3. Install reducer plug into rear drain hole on lower engine cover, then apply firm pressure until set. Repeat step 2 and 3 on other lower engine cover.

If “Loctite Super Bonder” adhesive is not available, use an equivalent super glue that is gasoline resistant. Follow manufacturers recommendation for applying the adhesive.

⚠ Safety Warning: When using anaerobic adhesive, read the entire “Warning” label before using. This product contains cyanoacrylate ester. When not used properly, it can cause serious injury.

Factory illustration 1Factory illustration 2Factory illustration 3Factory illustration 4
OMC Service Bulletin No. 2150

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Permatex Aviation Form-A-Gasket Sealant

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.