
1. Remove cover from trim/tilt junction box. If white plastic washers A are under the head of mounting screws, the washers must be removed.
Remove battery cables from battery.
1 / 2. Remove the relay and terminal assemblies B for better access to the junction box mounting screws. Hold junction box in place so that washers between arm mount and mounting boss will not move. Remove one screw. Remove and save small flat washer C from under head of screw. Remove and discard large flat washer D and white plastic washer A.
2 / 3. Install a new washer, P/N 328703 E, on screw. Install small flat washer C which was removed. Install screw and tighten securely.
Hold junction box in place and follow same procedure for second mounting screw. Install relay and terminal assemblies. Install cover assembly. Install battery cables.
Submit a warranty claim for each motor that is modified. OMC will pay 1/2 hour of labor and for two new washers, P/N 328703, used in this repair procedure.


