OMC Service Bulletin No. 2152 - Shimming Procedure

Historical OMC factory service information covering shimming procedure for 1975 thru CO - 40 thru 60.

OMC Outboard Service Bulletin
Gearcase
No. 2152
May, 1985
Subject:Shimming Procedure
Models:1975 thru CO - 40 thru 60

Choose the appropriate procedure when shimming the pinion on 40 through 60 models. Revised shimming procedures:

1. If a new pinion and forward gear ARE BEING INSTALLED or you are servicing a gearcase stamped “S” in the trim tab pocket, use the following shimming procedure:

1. When using OMC Driveshaft Shim Gauge, P/N 320739, DO NOT subtract .007 inch from gauge reading.

2. When using OMC Pinion Thrust Bearing Shim Gauge, P/N 393185, use Gauge Bar, P/N 328365.

3. If new pinion and forward gear are being installed, stamp “S” in the trim tab pocket, if not already stamped.

2. If a new pinion and forward gear HAVE NOT BEEN INSTALLED or you are servicing a gearcase not stamped “S” in the trim tab pocket, use the following shimming procedure.

1. When using OMC Driveshaft Shim Gauge, P/N 320739, subtract .007 inch from gauge reading.

2. When using OMC Pinion Thrust Bearing Shim Gauge, P/N 393185, use Gauge Bar, P/N 328364.

Note: For greater accuracy, use OMC Pinion Thrust Bearing Shim Gauge, P/N 393185.

Factory illustration 1Factory illustration 2Factory illustration 3
OMC Service Bulletin No. 2152

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Bearing Race

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 320739

Search for original or compatible replacement part 320739

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.