
Subject: Fuel System Restrictions
Models: 275 and 3.6 XP/GT™ V-8
When planning the permanently installed fuel system, ensure that components comply with the requirements for V-8 models.
Anti-siphon protection is required with the boat at its normal, unloaded, static floating position. To provide anti-siphon protection, secure the primer pump, fuel filter and all distribution lines above the full fuel level of the tank. If this is not possible, install an anti-siphon valve for each pickup tube.
- Anti-siphon Valves: Must have a flow restriction pressure drop of no more than 890 mm (35 in.) of water at a fuel flow rate of 75,7 litres (20 gallons) per hour.
The fuel system requirements are the same as for previous V-6 models with the following exceptions:
Note Fuel Hose Primer Bulbs: Do not use primer bulbs on any V-8 motor installation. Fuel flow may be restricted resulting in permanent powerhead damage due to a lean fuel mixture.
⚠ Safety Warning: Do not use vinyl hose for fuel distribution lines for permanently installed fuel systems.
- Fuel Distribution Lines: Must be a minimum of 3/8 in. I.D. (inside diameter). Use U.S. Coast Guard approved Type A or Type B hose for all distribution lines.
- Fuel Distribution Fittings: Must be a minimum of 9/32 in. I.D. The I.D. of some fuel system fittings for 3/8 in. fuel hose may be less than 9/32 inch. These fittings must be replaced with the correct size fittings or eliminated from the fuel system.
- Fuel Line Vacuum Test: Vacuum reading must not exceed 5 in. of Hg (mercury) with all screens and filters clean. This provides a margin of safety for the vacuum warning switch that is factory set at 7 inches. For fuel system testing information, refer to Outboard Service Bulletin No. 2003, “Permanently Installed Fuel Systems.”
Note Permanently installed fuel systems must be tested for restrictions as a part of normal motor installation.