OMC Service Bulletin 2157 describes a propeller modification and diagnostic checks for hard-to-plane boats using 85 through 140 HP outboards.
OMC Outboard Service Bulletin
Propellers
No. 2157
January, 1986
Subject:13-1/2 in. Diameter SST Raker® Propeller ModificationModels:All 85 thru 140 Using Thru-Hub Exhaust PropellersProblem:Poor acceleration of hard-to-plane boats
Factory Figure 1 showing three ventilation holes on SST Raker propeller

Solution - Modify the propeller by enlarging three 6 mm (7/32 in.) holes A to 8 mm (5/16 in.) holes. The holes will have no affect on top speed, maximum RPM, or ventilation in turns. Incorrect hole size will result in no improvement or in excessive ventilation, particularly in turns.

Enlarging the holes allows exhaust gasses to bleed onto the propeller blades causing controlled ventilation during acceleration. This allows the motor to turn higher RPM under acceleration, providing more power to plane the boat. Review the Diagnostic Procedure for additional items that will contribute to poor acceleration.

CR85-65

Diagnostic Procedure - The boat and motor should be inspected for the following conditions:

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Propeller Wrench

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.