OMC Service Bulletin No. 2174: Tiller Handle and Cable Service

1986 OMC service procedure for tiller stop-switch wiring and spiral wrap on Tiller 4 Deluxe through 55 models.

OMC Outboard Service Bulletin
Midsection
No. 2174
October, 1986
Subject:Tiller Handle and Cable ServiceModels:Tiller 4 Deluxe thru 55

When stop switch wires become disconnected, chafed or broken, engine will not shut off when stop switch button is pushed.

To prevent disconnection of the stop switch wires when the tiller handle is raised, follow this procedure for models with spiral wrap securing the stop switch leads. This procedure will ensure that the leads will not be damaged.

1Starting with the stop switch assembled in the handle, screw idle stop switch all the way out (counterclockwise).
2Wrap leads around throttle cable, using only two evenly spaced and flat spirals. Secure with tape as shown.
3Apply spiral wrap starting at the twist grip.
Factory figure 1Factory figure 2Factory figure 3
CR86-111

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Universal Marine Control Cable End Connectors

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.