August 1986 factory revision to throttle cable preload instructions for the OMC Remote Control Adaptor Kit P/N 174380 on CD and later 6 through 8 HP models.

Follow these revised instructions in addition to the Installation Instructions, P/N 124917 of 2/86, provided with the Remote Control Adaptor Kit.
The following information provides throttle cable preload instructions that must be followed to allow proper remote control operation.
Revision to Installation Instructions page 9, Step 4., No. 4
4. Thread throttle cable connector onto remote throttle cable until it is approximately centered on threads. The anchor screw tab must face the pivot pin end as shown.
Proceed with instructions 5 thru 9 of Step 4.
Revision to Installation Instructions page 10, Step 4., No. 10
10. Place remote throttle arm in the full throttle position. Place throttle advance lever on engine in the full throttle position. Adjust the throttle cable connector just enough to allow the mounting hole in the connector to expose the tapped hole in the mounting boss on the engine. The tapped hole must be offset toward the throttle advance lever as shown to correctly preload the throttle cable.
Proceed with remaining instructions.
Installation Instructions, P/N 124917 of 2/86, is being updated to supply the above information. The updated instructions can be identified by a Rev. 1 designation.
Factory photographs:

Suggested products related to this service bulletin. Verify fit and suitability before ordering.
Universal Marine Control Cable End Connectors
Search for these supplies on AmazonSearch for original or compatible replacement part 124917
Click here to search on eBayAffiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.