OMC Service Bulletin No. 2177: Identification of Failed Propeller Hubs

1986 OMC bulletin explaining how to identify normal, spun, crumbled, and bond-failed propeller hubs.

OMC Outboard Service Bulletin
Propellers
No. 2177
October, 1986
Subject:Identification of Failed Propeller HubsModels:V4 and Larger Outboards, OMC Cobra® Stern Drives, OMC Sea Drive®, and OMC® Stern Drives

The rubber hub in an OMC propeller transmits power from the motor to the propeller blades, and protects the motor from shock when the propeller strikes an underwater object. The rubber hub rarely fails on the above models but when it does, it will fail in one of several easily recognizable ways. See illustrations 1 thru 4.

1Normal Hub - Hub has NOT FAILED.
2Failed Hub - Hub has SPUN inside propeller. Hub surface is irregular and sticky, similar to uncured RTV.
3Failed Hub - Hub has CRUMBLED. Hub looks dry with broken fragments.
4Failed Hub - BOND FAILURE between insert and propeller hub (photo with insert and hub removed from propeller).

“CREEP” is when the hub rotates slightly inside the propeller; a mark on the hub will move relative to a mark on the propeller. The hub in an OMC propeller can “creep” momentarily during hard acceleration and some high performance boating conditions.

Creep: IS NOT A HUB FAILURE, not an indication that the hub will ever fail, nor is it detectable by the boat operator.

Before replacing a propeller hub on the above models, check the appearance of the front of the hub to determine if the hub has failed.

If a boat owner complains of PROPELLER SLIPPAGE on the above models and the propeller hub does not look like one of the failed hubs (figures 2 thru 4), check the motor, boat bottom, and installation, and question the boat owner about operating conditions to find the problem that could cause the symptom described.

Factory figure 1Factory figure 2Factory figure 3Factory figure 4
CR86-90