OMC Service Bulletin No. 2182: Boring and Honing Cylinders Oversize

November 1986 guidance on boring and honing oversize cylinders for outboard and OMC Sea Drive models.

OMC Outboard Service Bulletin
PowerheadNo. 2182November, 1986
Subject:Boring and Honing Cylinders Oversize
Models:All Outboard and OMC Sea Drive® Models

When new piston designs are implemented, they replace older designs for service. The new pistons are sized, taking into account their design and expansion rate. Piston-to-cylinder clearance may be different than originally specified. When boring and honing cylinders oversize, the finished size should be standard bore plus 0.020 inch or 0.030 inch. Refer to the Parts Catalog for the available oversized pistons before boring cylinder. Using this procedure will provide the proper piston skirt clearance. Cylinder measurements should be taken to determine if the damaged or worn cylinder exceeds the maximum oversize diameter; standard plus 0.030 inch. Standard bore sizes are listed in the Service Manual.

If a cylinder is already oversize and is worn beyond the maximum oversize, or if the cylinder is damaged so it will not “clean up” when bored to maximum oversize, then the block must be replaced.

Note If boring is necessary, it is recommended and approved to bore only the damaged cylinders in a powerhead.

This bulletin supersedes all other recommendations.

CR86-81

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Cylinder Hone Tool, Piston Ring Compressor

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.