OMC Service Bulletin No. 2188 (March 1987) addresses rough idle and acceleration - cu 65 and 70.
OMC Outboard Service Bulletin
Fuel System
No. 2188
March, 1987
Subject:Rough Idle and AccelerationModels:CU 65 and 70Problem:Engine runs lean at idle, idles poorly in gear, runs lean or may run rich (four cycles).Solution:Revise spark-throttle setting and carburetor idle air bleeds.

1. Inspect throttle cam mark(s).

①   ● Single marked cam Ⓐ requires no modification; follow steps 4 through 7 for correct synchronization.

②   ● Double marked cam Ⓑ requires relocation of cam mark and replacement of the carburetor air bleeds. Continue following steps 2 through 7.

2. Remove and replace all three carburetor air bleed jets with .033 idle air bleed jets P/N 320015.

②   3. Measure distance from center to center of double marked cam Ⓑ. Scribe permanent third new mark Ⓒ equal distance under lower short mark.

① ②   4. To synchronize single cam Ⓐ and modified cam Ⓑ:

  • Loosen cam follower screw and move follower away from cam.
  • All carburetor throttle plates must be synchronized and completely closed.
  • With a propeller installed, start and idle engine in the water. Shift into forward gear and adjust idle stop screw to obtain 725 ± 25 RPM.

(Continued)

③   ● Adjust preliminary throttle pickup point.

Shut off engine. Align cam mark to split exact center of follower by adjusting the thumb wheel Ⓓ and cam follower Ⓔ. Tighten locknut Ⓕ and recheck alignment.

④   ● Adjust final throttle pickup point.

With cam mark splitting exact center of follower, place a .005 in. feeler gauge between cam and follower; tighten cam follower. Carburetor throttle plates must be closed.

  • With a propeller installed, restart and run engine in water. Shift into forward gear and advance throttle up to 3000 RPM. Slowly return to idle, cam follower should rotate freely. If not, adjust trunnion of throttle cable until roller rotates freely. Repeat test after adjustment.

5. There is no pickup timing specification, step 4 is the equivalent.

6. Adjust wide open throttle (W.O.T.) stop to ensure carburetor throttle plates are exactly horizontal at W.O.T.

7. Refer to your Service Manual for all other adjustments.

8. The throttle cam picks up the throttle cam follower very quickly, any adjustment to idle speed requires reset of the pickup point.

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Carburetor Cleaner Spray, Jet Cleaning Wires

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 320015

Search for original or compatible replacement part 320015

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.