October 1987 OMC shop information bulletin on transom mounting height, spray and safe motor mounting for 28 ESL models.

OMC Outboard Service Bulletin
Shop Information

No. 2194
October, 1987

Subject:Motor Mounting Considerations
Models:28 ESL Models

We have received reports that the 28 ESL model, when installed on certain boats, produces an undesirable amount of spray.

Excessive spray may be caused by the motor being mounted too low on the transom, incorrect transom height, incorrect transom angle, or too large a radius at the intersection of the boat bottom and transom.

Because of these possibilities, it is recommended that the boat be water tested before auxiliary mounting holes are drilled in the transom.

Before testing boat and motor:
• Be sure clamp screws are secure
• Attach a retention chain or cable between the motor and the boat

Test boat under controlled conditions:
• Operate motor at a significantly reduced throttle setting in turns
• Avoid rough water conditions

If excessive spray results, raise the motor in ¼ in. increments, testing the boat after each adjustment. Continue this procedure until a desirable position is obtained. Bolt the motor to the transom with the mounting hardware provided.

Note DO NOT raise the motor to a point where any part of the clamp screw plate is within ⅜ in. of the top of the boat transom.

⚠ Safety Warning: Failure to follow the above precautions can result in:

• motor coming loose from the transom
• loss of boat control
• possible injury to the boat operator or others

OMC Outboard Service Bulletin
Transom Dimensions
Ⓐ20 to 20½ in. dimension A* is the recommended transom height for the 28 ESL model when the transom angle is 14° ± 2°. Additional testing may be required to achieve acceptable performance when the transom angle varies.
Ⓑ14° ± 2°

* This dimension is measured at the transom centerline, perpendicular to the boat bottom, as shown.

Note These procedures and Safety Warnings may also apply to other models that do not have the Thru-Hub™ exhaust feature.

Transom height and angle illustration with A and B dimensions

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Outboard Transom Support Plate

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.