OMC Service Bulletin No. 2196 - Hard Starting, Rough Running and RPM Limited to 2500

Published November 1987, this bulletin identifies improperly sealed cylinder head temperature switches affecting certain CC V4 and V6 loop-scavenged outboards. It includes the repair procedure and affected model and serial number ranges.

OMC Outboard Service Bulletin
Ignition System

No. 2196
November, 1987

Subject:Hard Starting, Rough Running and RPM Limited to 2500
Models:CC V4 and V6 Loop Scavenged Models Listed
Symptoms:

1. The motor will go into the “S.L.O.W.” feature, (falsely indicating an overheat), causing a rough running condition and limiting maximum RPM to 2500.

2. The QuikStart™ feature may not function properly causing a hard starting condition.

Note Either or both symptoms is possible.

Problem:
Some early production models have been built with an improperly sealed port cylinder head temperature switch. The illustrations show the difference between a properly sealed switch (figure 1) and an improperly sealed switch (figure 2). Notice on figure 2 that the bare wire ends and terminal pads are exposed, (not covered by the clear sealing compound as in figure 1).
Solution:

1. Seal the entire top of the temperature switch using an electronic grade (noncorrosive) RTV sealant (available at most electronic supply stores).

2. Replace the temperature switch using a new temperature switch P/N 583789.

Note It is important that the temperature switch be repaired or replaced on ALL motors that fall within the affected model/serial number ranges.

When replacing the switch, add OMC Gasket Sealing Compound around the switch leads where they pass through the rubber seal and to both sides of the rubber sealing washers. File a warranty claim for each temperature switch replaced. The flat rate labor allowance is 0.7 of an hour. The new temperature switch P/N 583789 is available from your OMC Parts and Accessories Distributor.

Figure 1, properly sealed temperature switchFigure 2, improperly sealed temperature switch
(Continued)

Model/serial range of outboards affected:

ModelBeginning
Serial
Number
Ending
Serial
Number
E120TLCC17373511737624
E120TXCC17389011738993
E140TLCC17398511740199
E140TXCC17417011741741
E200TXCC17435011743591
E200STLCC17423761742454
E225TLCC17441011744107
E225TXCC17446261744818
BE140TLCC17413511741391
BE225TLCC17444011744419
BE225TXCC17460011746011
J120TLCC77380767738318
J120TXCC77398017739807
J140TLCC77406267740780
J140TXCC77427517742781
J140CXCC77496267749649
J200STLCC77434767743575
J200TXCC77441517744256
J225TLCC77447017744750
J225TXCC77454767745615
J225PLCC77452017745219
BJ120TLCC77393517739398
BJ140TLCC77423017742346
BJ225TXCC77468017746817

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Outboard Ignition Spark Tester

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 583789

Search for original or compatible replacement part 583789

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.