OMC Service Bulletin No. 2199 - Inability to Set 950 RPM Engine Speed During Timer Base Adjustments of the Synchronization Procedure

This bulletin identifies a replacement throttle arm stop screw for certain early CC 120 and 140 HP Johnson and Evinrude outboards and early 2.0 litre JAS OMC Sea Drive systems.

OMC Outboard Service Bulletin
Shop Information

No. 2199
January, 1988

Subject:
Inability to Set 950 RPM Engine Speed During Timer Base Adjustments of the Synchronization Procedure
Models:
Early “CC” 120 and 140 Johnson® and Evinrude® Outboards
Early 2.0 Litre “JAS” OMC Sea Drive® Drive Systems
Problem:
Throttle arm stop screw Ⓐ P/N 334220 (¼-20 x 1⅝ in.) may not be long enough to allow proper linkage adjustment.
Solution:
Replace the throttle arm stop screw with a new throttle arm stop screw P/N 334219 (¼-20 x 2 in.). Refer to Section 1, Synchronization and Linkage Adjustments, of your service manual for adjustment procedures. The new throttle arm stop screw P/N 334219 is available through your local OMC Parts and Accessories Distributor.
Throttle arm stop screw location, A

Related products

Throttle arm stop screw P/N 334219 - recommendations coming soon.

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

eBay: OMC / Evinrude OEM part 334220

Search for original or compatible replacement part 334220

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.