OMC Service Bulletin No. 2200 - Driveshaft Shimming Procedure

This bulletin explains driveshaft shimming adjustments according to identification letters M, G, or L stamped in the driveshaft seal housing cavity.

OMC Outboard Service Bulletin
Gearcase

No. 2200
February, 1988

Subject:
Driveshaft Shimming Procedure
Models:
CU and CC, 35 - 40 - 48 - 50 and 75
1
Prior to shimming the driveshaft, check the cavity forward of the driveshaft seal housing for a stamped identification letter, “M”, “G” or “L”.

• If an identification letter is NOT stamped in the cavity, follow your OMC Service Manual for the gearcase driveshaft shimming procedure.

• If an identification letter IS stamped in the cavity, adjust the OMC Service Manual shimming procedure according to the following listed letters:

• Stamped letter M - Add 0.003 in. (0,076 mm) to the total amount of shimming determined by the Service Manual procedure.

• Stamped letter G - Use total amount of shimming determined by the Service Manual procedure.

• Stamped letter L - Subtract 0.003 in. (0,076 mm) from the total amount of shimming determined by the Service Manual procedure.

Figure 1: stamped driveshaft seal housing identification letter

Related products

Gearcase shimming supplies - recommendations coming soon.