OMC Service Bulletin No. 2206: Failure of Starter Motor to Operate

Electrical ground connection troubleshooting for OMC 9.9 and 15 HP electric-start outboards.

OMC Outboard Service Bulletin
Electrical System
No. 2206
July, 1988
Subject:Failure of Starter Motor to Operate
Models:9.9-15 Electric Start - All Models

Problem:

1The electric start circuit includes not only the start button, neutral start switch and starter, but also the negative or “ground” side connections. These are the battery ground cable to steering bracket connection A, the steering bracket to ground strap connection B, and the ground strap to exhaust housing connection C. These connections are just as important as the positive (red) starter leads.

Missing or improperly located star washers plus corrosion at ground strap connections and at the battery ground cable connection can cause a loss of continuity that will prevent the starter motor from operating.

Test of Starter Ground Connections (By Substitution)

⚠ Remove wires from spark plugs.

2Connect the motor's positive (red) battery cable to the positive terminal on a battery. Temporarily connect a separate battery ground cable or jumper cable from the negative terminal on the battery to the ignition coil ground screw D. The motor's regular battery ground cable must not be connected to the battery.

Push the start button.

If the starter motor operates now, but did not operate with the normal ground cable, the ground connections are bad.

Figure 1 ground strap assemblyFigure 2 ignition coil ground screw

(Continued)

CR88-35

Solution:

3Check to see if there is a star washer between the ground strap and the exhaust housing at location E (some models on starboard side, some on port).

4If the star washer is missing or not at the correct location, install the P/N 306488 star washer at connection C and between the other end of the ground strap and the steering bracket at connection B. Remove any paint or corrosion under the washers. See Section 4, Powerhead Removal in the Service Manual for procedures to gain access to the ground strap to steering bracket screw at connection B.

45The attachment of the negative (black) battery cable to the steering bracket at location A must be as shown. Remove any paint or corrosion. One P/N 306799 star washer must be next to the bracket, the battery cable must be next, then the cable clamp, another star washer, and the nut.

Figure 3 ground strap star washer locationFigure 4 steering bracket assemblyFigure 5 negative battery cable attachment

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Dual Battery Switch, Battery Box

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 306488

Search for original or compatible replacement part 306488

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.