January 1985 OMC Service Promotion describing a lifting eye for installation or removal of stern drive vertical drives.

The following procedure enables one person to install or remove a vertical drive.
1Obtain a plain eye bolt A or shoulder eye bolt B 1/2-13X1 minimum thread length from your local hardware store.
2Remove the oil level dipstick and gasket from the exhaust cover.
3Thread the eye bolt into the oil level hole, engaging all the threads of the exhaust cover. When the eye bolt has a nut, securely tighten nut against exhaust cover. If shoulder eye bolt B is used, tighten against shoulder.
4Use a 9/16 in. wrench or socket to remove the tilt quadrant C from the upper gearcase for removal or installation of the vertical drive.
5Use an adequate hoist to lift or lower the vertical drive.
After installation of the vertical drive, install the tilt quadrant C, and tighten the three retaining screws to a torque of 27-34 N·m (20-25 ft. lbs.).
23 Remove lifting eye. Replace the oil level dipstick gasket if damaged and install oil level dipstick into the exhaust cover.




