OMC Service Bulletin No. 2231 - Gearcase Speedometer Pickup

August 1990 gearcase bulletin explaining speedometer hose routing on Evinrude Intruder and Johnson FastStrike V6 outboards.

OMC Outboard Service Bulletin
Gearcase
No. 2231
August, 1990
Subject:Gearcase Speedometer Pickup
Models:Evinrude Intruder™ and Johnson FastStrike™

Some 1991 (EI) and newer V6 outboards and service gearcases are equipped with a speedometer pickup. If you use this feature, connect the speedometer hose to the elbow located on the front of the gearcase.

1 Route speedometer hose next to the steering arm and down through pivot shaft A.

2 Route hose between lower mount bracket B and exhaust housing.

Cut the elbow’s rubber cap when removing it to avoid damaging elbow. Wet end of hose. Support bottom of elbow and attach hose.

Cut speedometer hose just forward of steering arm and install hose connector P/N 123692, to allow a convenient disconnection point if engine is removed for service. Route and clamp speedometer hose with other engine cables to avoid excessive slack or chafing.

Note For off season storage, disconnect hose at connector and blow standing water out of gearcase elbow and hose.

Figure 1 - speedometer hose routed at steering arm, point A
Figure 2 - hose routing at lower mount bracket, point B
CR90-43

Related marine products

eBay: OMC / Evinrude part 123692

Listings matching the part number

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.