OMC unpacking instructions for 1991 and newer V4 and larger outboards, including the recommended lifting fixture.

Improper unpacking procedures cause motor cover damage.
Follow this procedure when uncrating motors. Do not open the motor carton by cutting on three sides and flipping the carton top back on a “hinge.”
V4 and larger outboards are shipped in cartons that have wood supports attached to the inside to provide increased protection to the motor during shipment. The wood can damage the motor cover if that part of the carton is not removed carefully. There is enough clearance between the wood and the motor cover to allow a “hinged” removal of the carton top.
The motor is shipped with the powerhead down. Before opening the carton, turn it so the powerhead is up.
1 Cut through the carton at the upper dotted line.
2 Carefully lift the carton top straight up and off.
3 Remove the motor cover. Install OMC Lifting Fixture (P/N 396748 with ⅞” screws) on the flywheel. Attach a hoist with sufficient capacity to lift the engine to the lifting eye.
Cut through the carton on the lower dotted line. Carefully, lift the motor from its carton. Remove all other components.
Important Motor damage caused by improper unpacking procedures is not covered by warranty.



Listings matching the part number
Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.