OMC Service Bulletin No. 2245 explains retaining clip fitment on 9.9 and 15 HP outboards with remote controls.
OMC Outboard Service Bulletin
Remote Control
No. 2245
August, 1991
Subject:
Installation of Throttle Cable Trunnion
Models:
9.9/15 with Remote Control
Problem:
Some engine covers on a small number of motors are too thick to allow retaining clip to seat in its groove in the throttle cable trunnion.
Solution:
Modify retaining clip to fit into throttle cable trunnion groove.

When installing the retaining clip Ⓐ on the throttle cable trunnion, the clip must snap into the groove Ⓑ on the trunnion. A small number of 9.9/15 models have lower motor covers which are slightly thicker than normal. On these motors the throttle cable trunnion will not extend far enough through the lower engine cover to accept the retaining clip Ⓐ in its groove Ⓑ. Polish the flat side of the retaining clip until it will fit into the groove.

If you are installing Remote Control Adaptor Kit P/N 435448, notice that there is a thin and a thick retaining clip. Follow the procedures in the instruction sheet and install the thickest clip that still provides complete engagement of the groove.

⚠ All of the retaining clip must be in its groove. If it is not completely in its groove, the clip could be pushed out during motor operation. The operator would be unable to control the throttle.

Throttle cable trunnion retaining clip with A and B labels

⚠   Safety Related

Related marine products

eBay: OMC / Evinrude part 435448

Listings matching the part number

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.

Related products

Remote control adaptor and throttle cable retaining clip parts - recommendations coming soon.