OMC Service Bulletin No. 2246 addresses low fluid level and erratic trim and tilt operation on 1990 and newer 40, 48 and 50 HP models.
OMC Outboard Service Bulletin
Midsection
No. 2246
August, 1991
Subject:
Erratic T’N’T Operation
Models:
1990 and Newer 40, 48 and 50
Problem:
Low Fluid Level

1 Filling reservoir with trim unit at an angle, even as little as a normal transom angle, reduces amount of fluid in reservoir.

1 Fluid level drops as cylinder extends. If reservoir does not contain enough fluid, air will be drawn into pump inlet Ⓐ. Operation will become jerky, or motor will not reach full tilt.

Solution:
Fill reservoir with trim unit VERTICAL.
  • Bow of boat/trailer can be lowered, or stern can be lifted with a hoist, until trim unit is vertical.
  • Tilt pin can be removed from stern brackets, and let trim unit hang vertically.
  • If motor is off boat, motor can be positioned so trim unit is vertical.
  • If trim unit is off motor, place it vertically on bench.

2 3 With cylinder extended and unit vertical, fill reservoir to fill hole, and install plug.

Cycle trim cylinder down and up once and recheck fluid level. Repeat as needed.

When fluid level remains at fill hole, cycle unit down about an inch and then up. Hold switch up for 5 seconds with unit stalled at full tilt up position to purge air from cylinder.

Check fluid and repeat short cycle until fluid level remains at fill hole. Tighten plug to 45-55 in. lbs. (5-6 N·m).

Figure 1 trim reservoir angleFigure 2 reservoir fill plugFigure 3 vertical trim unit

Related products

Power trim and tilt service parts - recommendations coming soon.

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Power Trim

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.