OMC Service Bulletin No. 2253 - Cylinder Head Gasket Orientation

This March, 1992 OMC bulletin addresses cylinder head gasket orientation for 90° Loop V4 & V6 Engines, 3.685 in. Bore.

OMC Outboard Service Bulletin
Powerhead
No. 2253
March, 1992
Subject:
Cylinder Head Gasket Orientation
Models:
90° Loop V4 & V6 Engines, 3.685 in. Bore
Problem:

From 1988 through November, 1991, all 90° Loop V4 & V6 cylinder head gaskets had a symmetrical design that allowed you to install them with either side facing the cylinder head.

In December, 1991, the cylinder head gasket was changed to an asymmetrical design that requires one side to face the cylinder head.

If this orientation is not followed during servicing, the gasket could leak and allow water into the cylinders.

Solution:

The service replacement head gaskets listed in the 1992 parts catalogs and in this bulletin incorporate this change.

These gaskets identify which side must face the cylinder head by having “HEAD SIDE” embossed into or stamped onto the correct gasket surface.

Follow all service procedures in your service manual when installing these gaskets.

V4333549
V6333670