
Some 1992 60° Loop V6 engines could have deformed timing wheel washers or a mismatch in dimensions between the timing wheel and the crankshaft. These situations could reduce the clamping force on the timing wheel.
Depending on the looseness, the operating symptoms could be one or both of the following:
- High speed ignition misfire or erratic ignition.
- Loss of full throttle performance, loss of RPM, and retarded timing.

Following the procedures in your service manual, remove the timing wheel cover. Remove the timing wheel retaining screw and washer.
- Discard the screw and washer.
Remove the timing wheel Ⓑ and inspect the center bushing for signs of wear or fretting.
- Replace the timing wheel if it shows signs of wear or fretting.
Note The timing wheel hub should be slightly taller than the crankshaft.
Install the timing wheel, new washer Ⓒ, P/N 125134, and new retaining screw Ⓐ, P/N 333955, following the procedures in the service manual.
- The timing wheel should now be clamped in place.
If the timing wheel is still loose, add a sufficient number of shims Ⓓ, P/N 913360, until the timing wheel is clamped in place.