Upper Motor Mounts

This December 1992 OMC bulletin explains upper motor mount movement on 1991 and early 1992 60° V6 outboards and identifies the replacement mount kit.

OMC Outboard Service Bulletin
Midsection
No. 2268
December, 1992
Subject:

Upper Motor Mounts

Models:

1991 (EI) and early 1992 (EN) 60° V6

Problem:

Upper motor mounts could shift and allow excessive fore and aft movement of the motor. This displacement could cause poor acceleration or a reduction of RPM at full throttle. The movement could also bend the shift rod, causing hard shifting.

Solution:

Replace damaged upper mounts with Upper Mount Kit, P/N 435602. This kit contains two upper mounts, P/N 435272, and two ½-13 x 2¼” screws, P/N 338302.

When removing the original mounts, also remove and discard the bumper parts. For installation procedures, refer to the Powerhead Section of the 1993 (ET) 60° LV Service Manual, P/N 508286. All service replacement powerheads include the new mounts and screws.

The old and new mounts can be identified as follows:

1P/N 435272 (new mount) has a blind hole for the mounting bolt and uses a ½-13 x 2¼” screw.

2P/N 434613 (old mount) has a thru-hole for the mounting bolt and uses a ½-13 x 3” screw.

Factory illustration 1Factory illustration 2

Related marine products

eBay: OMC / Evinrude part 435602

Listings matching the part number

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.