Modification, OMC Bearing Installer P/N 339750

This February 1993 OMC bulletin explains how to inspect and modify Bearing Installer P/N 339750 for 1993 and newer V6 and V8 outboards.

Service tools referenced: 339750.

OMC Outboard Service Bulletin
Service tools
No. 2270
February, 1993
Subject:

Modification, OMC Bearing Installer P/N 339750

Models:

1993 and Newer V6 and V8

Problem:

Recently you received Bearing Installer P/N 339750 in the 1993 Outboard Essential Service Tool Kit. The forward bearing pilot might be too long. The tool might bottom in the casting before properly positioning the bearing.

Solution:

1Measure the forward bearing pilot to determine if your tool is ok.

If dimension Ⓐ measures ¹³⁄₁₆ in. (20 mm), your tool is ok and no modification is required.

If dimension Ⓐ measures ³¹⁄₃₂ in. (25 mm), your tool will require modification.

2Modify the forward bearing pilot of the tool by machining a 45° taper. The taper should extend ⅜ in. (9,5 mm) down the pilot Ⓑ.

If you do not have the capabilities to modify the tool, return it to:

Hansen Machining
23426 Apollo Court
Lake Villa, IL 60046
(708-356-9552)

Hansen Machining will modify your tool and return it at no charge. Please include your return address and allow two weeks for machining and shipping.

Factory illustration 1Factory illustration 2

Related marine products

eBay: OMC / Evinrude part 339750

Listings matching the part number

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.