OMC Bulletin No. 2275 - Repainting

December 1993 OMC bulletin detailing outboard repainting, surface preparation and chromate conversion coating.

OMC Outboard Service Bulletin
Shop Information
No. 2275
December, 1993
Subject:
Repainting
Models:
All
Problem:
Sometimes the paint is damaged by abrasion, scratching, peeling or corrosion, and must be refinished. Unless the surface is prepared properly at each step, the new paint will not last.
Solution:

To produce a durable refinish, use the following procedure:

1. Remove all marine growth.

2. Remove all loose paint and corrosion by sanding or sandblasting.

3. Remove all traces of grease and oil. Wash unit with hot water and detergent. Roughen all painted surfaces with a Scotchbrite pad. Rinse thoroughly with water.

4. If there is bare aluminum it must be treated with a chromate conversion coating to improve paint adhesion and resist corrosion. Skip to Page 2 for that procedure.

5. If some paint remains on all surfaces, continue with Step 6.

6. Where the primer coat is thin or where the surface is unpainted, prime with PPG epoxy primer. Do not apply primer over old finish coat. Primer solvents must be allowed time to evaporate and the primer must harden before applying the finish coat. Allow 8 to 12 hours drying time.

7. Apply finish coat. The product parts catalogs and the OMC SysteMatched™ Parts & Accessories dealer catalog list OMC and PPG refinish numbers.

Important The surface must be CLEAN before applying each coat of paint. Follow the instructions carefully to produce a durable refinish.

(Continued)

CR93-18
Chromate Conversion Coating

1. Clean the entire bare area with an acid cleaner that DOES NOT CONTAIN FLUORIDE, such as Dupont 5717S or Parker Amchem Deoxidine 605 aluminum cleaners. Parker Amchem Aluma Prep #33 contains fluoride and is NOT a suitable cleaner for our alloys. Scrub the surface with a Scotchbrite pad until it is completely “wetted,” with no water beading or “water-breaks.”

2. Rinse thoroughly with water. The area must appear completely “wetted,” or the surface is not clean.

3. ⚠ While the surface is still wet from rinsing, treat all bare aluminum with Dupont 226S or Parker Amchem Alodine 1201 chromate conversion solution. Brush the chromate solution on the surface, adding additional solution as required for 2 to 5 minutes to prevent it from drying on the surface. Rinse the surface thoroughly with water and allow to air dry. Follow the label instructions exactly.

4. Go to Page 1 - Step 6.

Note Use these phone numbers if additional product information is required:

PPG - (800) 441-9695
Dupont - (800) 441-7515
Parker Amchem - (800) 456-3254

⚠ Safety Related

Related products

Marine refinishing supplies - recommendations coming soon.